|
|
Post by jaw12287 on Aug 7, 2017 16:51:08 GMT -5
So I may have goofed. I recently stopped by my local(ish) hobby shop to pick up a couple of cans of fluorescent spray paint but wasn't paying close enough attention to what I was grabbing. Long story short, I grabbed Polycarbonate spray instead of lacquer. Will this stuff bond to primed diecast or am I better off taking it back?
|
|
|
|
Post by alterrenner on Aug 8, 2017 4:52:54 GMT -5
Covered this a while back when I did the same thing! According to Calvin, the stuff dries flat, rock-hard, and is pretty much not sandable.
If you can get back to the store, return it.
--Frank
|
|
|
|
Post by jaw12287 on Aug 8, 2017 16:27:29 GMT -5
Covered this a while back when I did the same thing! According to Calvin, the stuff dries flat, rock-hard, and is pretty much not sandable. If you can get back to the store, return it. --Frank Damn. That's what I was afraid of. Thanks Frank! |
|
