Post by lazierfan on Jan 17, 2013 21:55:52 GMT -5
Below is a short little how to on the new BBS wheel inserts I am offering. First thing is to use a razor saw and cut the center sleeve off at the back of the wheel center. This part will be used on the inserts. Be sure to cut these off first before removing the center of the AMT kit wheel. Next remove the center of the wheel. There is a nice line there to use as a guide. Next after painting the BBS insert glue it to the back of the wheel outer front half. Glue the center sleeve in place on the back side of the wheel. This will give you the same wheel offset as the original kit wheels. If anyone that orders these has any questions just let me know and I will help you out. Just a FYI...I used rejects for my set that is why there are the gaps on the back side.
Last thing is to sand the rear inner halfs down..approx 1/16 of an inch ....I just kept sanding them until they fit flush with the tire.
Last thing is to install the kit center nuts.
Last thing is to sand the rear inner halfs down..approx 1/16 of an inch ....I just kept sanding them until they fit flush with the tire.
Last thing is to install the kit center nuts.