|
|
Post by wrencher on Sept 2, 2008 10:47:55 GMT -5
|
|
|
|
Post by wrencher on Sept 2, 2008 10:51:12 GMT -5
Well I tried multiple photos, but this is the only one that I did right. I'll try others later. H.W.
|
|
|
|
Post by indy on Sept 2, 2008 11:51:00 GMT -5
What's your user name on PhotoBucket?
Jordan
|
|
|
|
Post by wrencher on Sept 2, 2008 12:52:35 GMT -5
My photobucket user name is kizzie11.
|
|
|
|
Post by indy on Sept 2, 2008 14:10:54 GMT -5
|
|
|
|
Post by indy on Sept 2, 2008 14:11:49 GMT -5
69 and 67, right?
Jordan
|
|
|
|
Post by wrencher on Sept 2, 2008 16:20:45 GMT -5
You are correct Sir. I was going to show the parts needed from the Gurney Eagle to use on the Brawner Hawk in another thread. The photo that is exploded is that one. BTW how did you post them all at once? Thanks, H.W.
|
|
|
|
Post by sandysixtysfan on Sept 2, 2008 16:38:21 GMT -5
As Gomer Pyle use to say, "Shazam!" Really great work.
|
|
|
|
Post by indy on Sept 2, 2008 16:39:42 GMT -5
Go to your Photobucket page and you will see the image with several boxes below it. Click in the box next to IMG Code and it will flash "Copied" and all you have to do it come over here then click paste. I kept your Photobucket open in one window and the openwheel forum open in another so I could get all the photos posted together.
HTH
Jordan
|
|
|
|
Post by 2lapsdown on Sept 2, 2008 18:19:00 GMT -5
This post came at a perfect time for me. I'm just finishing my 67 winner and planning to build the 69 winner ASAP. Nice job on both. Are the suspension pieces in the photo from Bill's kit or taken from another? Again, nice work, very inspiring.
|
|
|
|
Post by wrencher on Sept 2, 2008 18:47:45 GMT -5
On the 69 Brawner Hawk, all of the suspension parts as well as the engine/transaxle assy are from the MPC kit. The rear suspension took the longest to do because of fit-up. The front end was a piece of cake. I just drilled four holes, cut a notch in the bottom and they went together pretty well. One thing I think is pretty important to mention is the rear suspension and rear engine mount. It was taken from the Gurney kit too. All of the rear suspension mounts to this just as they did on the MPC kit. I drilled out the intake ports of the engine to .093" and used Radio shack hollow core solder for the runners. look at the top picture that jordan sent and it has most all of the parts needed. Hope this will help. I will be posting finished photos soon. Hope this will help someone. H.W.
|
|
|
|
Post by 2lapsdown on Sept 2, 2008 20:04:39 GMT -5
Thanks
|
|
