|
|
Post by IndyCarModels on Aug 28, 2023 14:00:35 GMT -5
Can anyone tell me what is causing this problem. I've never had this happen before.   |
|
|
|
Post by GrandPrecision on Aug 28, 2023 15:04:08 GMT -5
Have you printed the file successfully before? If so, try using a different USB drive with the printer.
|
|
|
|
Post by Calvin on Aug 28, 2023 15:31:28 GMT -5
Never seen that happen before, but I'm just a 3d printing rookie.
|
|
|
|
Post by IndyCarModels on Aug 28, 2023 15:34:18 GMT -5
Have you printed the file successfully before? If so, try using a different USB drive with the printer. Yes. Everything was printed successful before. I will relevel the base again and then try this. Thanks and I will let you know if it works. Terry |
|
|
|
Post by IndyCarModels on Aug 28, 2023 15:35:05 GMT -5
Never seen that happen before, but I'm just a 3d printing rookie. You mean I know more about something than you? |
|
|
|
Post by Calvin on Aug 28, 2023 15:52:07 GMT -5
Never seen that happen before, but I'm just a 3d printing rookie. You mean I know more about something than you? Lol 😂 I bet you know alot more than I know. I've put very little effort into understanding 3d printing and have got left in the dust. |
|
|
|
Post by indycals on Aug 29, 2023 0:36:58 GMT -5
I've been printing since march and I've had a lot of failures - but every failure was a learning experience. And every failure was user generated. Failing to tighten the build plate, running out of resin, failure to install the build plate. Most failures are due to support issues. But I've never seen a failure like this. This looks like a glitch induced file issue. After I create my CTB files I run them through an app called UV tools - since I started using UV tools my failure rate dropped significantly. I'm probably barely scratching the surface with what it can do. Autodesk Fusion 360 is great for sorting out STL file issue, but if you are using a good slicer it should detect STL file issues and repair simple ones.
|
|
|
|
Post by IndyCarModels on Aug 29, 2023 9:26:36 GMT -5
I think I have found the problem. The LCD screen has some small vertical cracks. I just ordered a replacement screen so hopefully that solves the problem.
Thanks for the help guys.
|
|
|
|
Post by indycals on Aug 29, 2023 14:06:53 GMT -5
I think I have found the problem. The LCD screen has some small vertical cracks. I just ordered a replacement screen so hopefully that solves the problem. Thanks for the help guys. That's good to know. That was a really funky failure. |
|
|
|
Post by IndyCarModels on Aug 29, 2023 15:20:54 GMT -5
I couldn't see the cracks until I turned on the light source.
|
|
